Logo

C3244 Engine Code Repair

Meaning of C3244 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C3244 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for C3244 code is occuring now you should check C3244 repair processes.
Now don't ask yourself; What should you do with C3244 code ?
The solution is here :

C3244 Possible Solution:

C3244 Engine

Excessive air inflow can be caused by a vacuum leak, a dirty sensor or, an exhaust gas recirculation valve not closing properly. If the problem is not enough fuel, the culprit may be dirty injectors or fuel filters, a weak fuel pump or a leaky fuel pressure regulator. The lean fuel mix error may be accompanied by rough idling, engine misfires, hesitation during acceleration and overall poor engine performance.

C3244 Code Meaning :

C
OBD-II Diagnostic Chassis (C) Trouble Code For Engine

3
Ignition System Or Misfire

2
Fuel Rail/System Pressure - Too High

4
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)

4
Exhaust Gas Recirculation Sensor B Circuit High

Regarding the C3244 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

C3244 OBD-II Diagnostic Chassis (C) Trouble Code Description

C3244 engine trouble code is about Exhaust Gas Recirculation Sensor B Circuit High.

Main reason For C3244 Code

The reason of C3244 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

C3244 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.